KJT High quality SK12 Hall Effect Proximity SINGLE CHANNEL 12V 48V DC Wheel Speed Sensor
Features
• Ferrous target geartooth speed sensor
• Stainless steel M12 threaded barrel
• Electronic protection against severe and automotive environments
• Self adjusting magnetic range
• Three-wire (voltage output)
• EMC Protection (Consult Littelfuse)
• Short circuit/reverse voltage protection
Specifition:
| Mounting |
F NF |
| SN[mm] |
2mm 4mm |
| Power supply |
20…250VAC / 10-30VDC |
| Housing size |
M12*54 |
| Thread size |
M12*1*40 |
| Output |
NC |
| Temperature drift |
≤±10% |
| Hysteresis |
1…20% |
| Repeat accuracy |
≤3% |
| Load current |
≤200mA |
| Residual voltage |
≤2.5V |
| Consumption current |
≤25mA |
| Protection circuit |
Surge,short-circuit,reverse polarity |
| Indicator |
Yellow LED |
| Ambient temp. |
-25…70℃ |
| Ambient RH |
35-95% |
| Speed |
6...3000 t/minutes |
| Protection degree |
IP67 |
| Housing material |
Nickel plated brass |
| Connection |
PVC Cable 2m |
Summary:
The SK12 Hall Effect SINGLE CHANNEL sensor adopts the principle of electromagnetic induction to achieve the velocity measurement, It has a large output signal, No need to zoom, Anti-Interference, No external power supply needed, Can be used in harsh environment like Smoke, Oil and Gas, Water Vapors and so on. It can be replaced with the same kind of foreign products. Our products are mainly supplied with steam turbine, We have already imported 3 0 0 M W, 6 0 0 M W supporting units, It is widely used in national defense chemical industry, Textile and other fields.
Working Principle:
Before using make sure the gear is mounted on the shaft for speed measurement traight, Helical or Grooved disk gear all can be used ount the sensor on the bracket, Adjust the Clarence between the sensor and the gear tooth to be approx. 1mm. When the gear starts rotating with the shaft, According to the principle of electromagnetic induction, a voltage pulse signal is generated at both ends of the internal coil of the sensor, The Z-voltage pulse signal is generated when the axis is rotated, According to the type. flush
Given that NPN= Measured shaft speed in Rotation/Minute, Z= Number of gear teeth.
When the gear tooth number is 60, the rotation of the axis is converted to a voltage pulse signal with frequency of f, and the signal is sent to the corresponding digital speed.
Product Tags:
|
|
12V 48V DC Gear Speed Sensor , SK12 Hall Effect Proximity Wheel Speed Sensor Images
|
